Specifications & Dimensions
|Dimensions and Weight:|
|Item Weight (lbs.):||1.6|
Ratings & Reviews
Craftsman Heavy Duty Air Line Filter and Regulator with Gauge has adjustable locking regulator and full flow ports to allow maximum air flow. Provides efficient water and particle removal and features an easy to read water level indicator. Features 3/8 in. NPT threaded input and output and two 3/8 in. to 1/4 in. NPT threaded reducers to accomodate smaller diameter hose. Rated to 175 PSI.
- Available for Gift Wrap
Added on July 26, 2010
Overall, others give this:
Reviewers may have received a benefit, like a sweepstakes entry or rewards program points, in exchange for writing a review.
Those benefits were not conditioned on the positive or negative content of the review.
Most Helpful Reviews
I was a little apprehensive after reading the reviews on if i should buy this regulator/filter. I decided that i needed to find out for myself if this thing is up too the challenge or not. Let me start out by saying that the entire unit is made out of metal except for the control handle on top which is disappointing, because the unit as a whole is very sturdy. In fact, my only complaint and the reason this product does not deserve 5 stars is because the handle is made out of plastic and could very easily break under the wrong hands. I think sears should look at adding a square metal insert into the inside of the handle or beef it up in some other way. The regulator works great and if your careful the handle works fine as well.
Just what we needed, good heavy duty, mounted on the wall near the air compressor. Easy to hook up. would definitely buy again. Works great with my Craftsman air compressor.
Idaho Falls, ID
This regulator is rated up to 175 PSI. I keep my air compressor at 150 PSI I have had the plastic bowl crack 3 times on me. Not sure if it was just a bad lot or if it is a known issue. Other than that it seems to get the job done.
The reviewer indicated they are affiliated with this product.
Only expected a pressure regulator to allow me to control pressure. It failed. Difficult to set it at the 90 pounds I needed from my 60 gallon tank compressor. Pressure fluctuated wildly once set. Lucky it did not blow out my tool, but made sanding diffucult. The port cap for the Guage was glued tight, the soft metal was not strong enough to overcome the seal and therefore I was stuck with the Guage on the wrong side for my application. When using the blower, the air blast was noticeably wetter than without the built in filter. In short it failed miserably. Lucky it did so immediately giving me time to return it. I suppose in the interest of protecting my expensive tools, Ingersoll, snapon,... I should invest in a good regulator, filter and dryer.
I bought this less than a year ago, it's a piece of garbage on two accounts. 1. The regulator never worked consistently. I can't always regulate A/P without shutting off the air and unscrewing the regulator completely, re-seating it and then closing it up. 2. The polycarbonate bowl (water trap) cracked at the bottom where the drain valve is seated. If the drain seat was too tight, that's from the factory (China) and should be a covered item. The problem is they don't sell or stock the bowl separately. After getting the run-around using the phone, my solution was to buy the Husky regulator and swap out the bowls until I can replace the whole thing.
Most of my tools are Craftsman. I like them and they're affordable. But this product is a complete piece of junk. I'm on my fourth one in 8 months (can't find my receipt so I have to keep exchanging it) and I only use my compressor 1 to 2 times per week. The first one came out of the pkg broken, the second lasted a couple months before spewing water through my tools, the third one broke in two days and the fourth lasted a few days before spewing water. I just ordered a different one from Northern Tools so I can prime my car and keep my tools from being ruined. Doesn't Sears read these reviews?
Had it installed for 6 months before the bowl burst. Even before it blew it wouldn't allow enough constant CFM for tools. I would not recommend this item for any use. STAY AWAY!! Save your money!! Bought an Ingersoll Rand 2000 series. Works great.
- Free shipping! Orders $59 or more Offer ends 05-Apr-2014 See details.
- Spend $199 in tools from Sears and enroll in the Tool of the Month - www.sears.com/toolofthemonth Offer ends 31-Dec-2014 See details.
- Use your Sears Card and Save! Extra 5% off Tool items Sold By Sears when you use your Sears Card. Offer ends 31-Dec-2014 See details.